×

WE ARE CURRENTLY EXPERIENCING DIFFICULTIES WITH OUR PHONE LINES.  PLEASE UTILIZE CHAT OR EMAIL TO CONTACT US UNTIL THIS IS RESOLVED.

Chevy Vintage Air Gen IV Electronic Servo Air Conditioning Kit, For Use With V-Belt Pulleys, 1956
Chevy Vintage Air Gen IV Electronic Servo Air Conditioning Kit, For Use With V-Belt Pulleys, 1956

Chevy Vintage Air Gen IV Electronic Servo Air Conditioning Kit, For Use With V-Belt Pulleys, 1956

$2,826.99 kt
Model:3000047
Condition: NEW
Availability:
ARRIVING SOON!
Estimated arrival: 10/08/2021 (If Ordered Today)
Fitment:
Select a Vehicle or refer to the Vehicle Fitment Tab below to verify that this part fits your vehicle.
Shipping Note:Oversize 2
Qty:

Can't Find your Part?

We'll find it for you. Give us a call at 855.444.6872 and we'll source that discontinued or hard to find part.

Why Choose Us?

No Brokerage or Duties - Canadian Owned & Operated - Shipped from Canada to your Door - Easy to Navigate Website - Access to New, Used & Discontinued Parts - Full Time Staff to Answer your Questions.

Disclaimer

Muscle Cars & Classics always recommends professional installation of our products. Buyer assumes risk of damage caused by improper installation.

The Best Cooling Available For Your Classic 1956 Chevy Sure-Fit In Dash Installation With Electronic Servos Use Your Original Heater Controls By Using The Included Control Panel Conversion Kit Allows For Blended Heat & Air Conditioning Like A Modern Chevrolet Includes Special Plastic Glove Box Liner To Clear Vintage Air Box This Chevy Gen IV Vintage Air conditioning unit is sure to keep you cool even on the hottest summer days. It includes all components needed to complete the installation except for belts and engine pulleys. Just install, charge and go! This is not a hang-on kit; it fits up under the dash, taking place of the original heater system. This Gen IV unit features fool-proof electronic servo controls that operate using the original deluxe heater control panel. These servos control an advanced ECM module for maximum efficiency. The air conditioning ducts are placed on the left, right and center of the dash for efficient cool air distribution. The under hood components are an easy bolt-on for either small block or big block Chevy engines. Some drilling/cutting is required on the passenger side radiator filler panel for the lines to the condensor. All of our Vintage Air systems use HFC-134A refrigerant. When ordering, specify small block or big block engine, short or long water pump, alternator on the driver side or passenger side, radiator in the V8 or 6-cylinder position and v-belt or serpentine belt drive. For serpentine systems only, the compressor bracket is not included. Keep you cool in the summertime with a Chevy Gen IV Vintage Air conditioning system!

The Vehicle Fitment Guide is to be used as a general reference. The data has been provided by our suppliers and manufacturers and may contain errors or incorrect data. Always refer to a professional to verify correct fitment for your vehicle.
Make Model Years
Chevrolet Bel Air 1955 - 1956
Chevrolet Nomad 1955 - 1956
Chevrolet One-Fifty Series 1955 - 1956
Chevrolet Two-Ten Series 1955 - 1956

Write a Review

Your Name:

Your Review:

Note: HTML is not translated!

Rating: Bad Good

Ask a question about

Chevy Vintage Air Gen IV Electronic Servo Air Conditioning Kit, For Use With V-Belt Pulleys, 1956:
Your Name:


Your Email:


Question: Note: HTML is not translated!

Related Products
Shipped from Canada
No Brokerage or Duties
Canadian Owned
Classic Chevy 2021