Adds Third Universal Joint To Steering Shaft Gives Tremendous Additional Clearance For Any Type Of Headers Bolts On No Welding Required Works With CCI Rack & Pinion Steering Kits
…
Replacement Shaft Allows Installation Of Rack & Pinion Without Cutting Shaft From Stock Steering Box Accepts Stock Or Aftermarket Steering Wheel At Top 3/4 Round x 35 Overall Length 3/4-36 Spline At Bottom Use With U-Joint P/N…
Updates Your Car To Modern Power Steering Modified To Fit Your 1955-57 Works With Stock Outer Tie Rods & Sleeves 14.1:1 Steering Ratio Mounts With P/N 53-75 Crossmember Requires Pump Pressure of 950 To 1050 psi Return Line Fitting 16mm…
Makes Your Classic Steer & Drive Like A Modern Car 14.1:1 Steering Ratio Bolts-On, No Welding Required The Rack & Pinion Is Rear Steer Like The Original Steering Linkage This Complete Kit Includes Everything Needed Installation Of…
For Big Block Or Small Block 1955-57 Chevy Vehicles
This System Replaces The Early Long Shaft Steering Box With An Optional New Tilt Column
All Mounting Hardware, Pump, Bracket, Reservoir And Universal Joints Are Also…
Replacement Remanufactured Rack & Pinion-Update Your Late Great Chevy To Modern Steering A True Bolt-In Conversion-Dramatically Improves Handling & Steering Response Conversion Includes Everything Needed-Rack & Pinion, Power Steering…
Replacement Remanufactured Rack & Pinion, Update Your Late Great Chevy To Modern Steering A True Bolt-In Conversion Conversion Includes Everything Needed: Rack & Pinion, Power Steering Hoses, Pump, Brackets & Steering Shaft This…
Replacement Kit Super Strong Tubular Steel Design 14.1:1 Steering Ratio Includes Hardware Bolts-In Stock Frame Holes The Rack & Pinion Is Rear Steer Like The Original Steering Linkage Primer Finish…
For Use With Our Rack Unit P/N 53-76 To Maintain Original Turning Radius May Be Use With 605 Or 670 Power Steering For Tighter Turning Radius Should Not Be Used With Non-Power Steering…
Replacement Shaft Kit Connects Stock Steering Column To Rack & Pinion Unit Includes New Steering Column Shaft So You Don't Have To Cut Your Stock Steering Shaft/Box Includes 3/4 DD To 3/4-36 Spline Upper Joint, 3/4 DD To 17mm DD…
Adds Third Universal Joint To Steering Shaft Gives Tremendous Additional Clearance For Any Type Of Headers Bolts On-No Welding Required Works With CCI Rack & Pinion Steering Kits Works With 3/4 Double-D Shaft…
Connects Rack & Pinion Unit P/N 53-76 To Steering Column Use With U-Joints P/N 53-154 & 53-153 Or 53-152 Cut To Fit As Needed No Welding Required 3/4 x 18 DD…
Makes Your Classic Steer & Drive Like A Modern Car Bolts-On, No Welding Required 14.1:1 Steering Ratio Includes All Components Except Pulleys, Pump & Brackets The Rack & Pinion Is Rear Steer Like The Original Steering Linkage…