Protect your clutch system from dirt, debris, and moisture with this high-quality Clutch Fork / Bellhousing Boot, designed for 1955-1983 GM cars and trucks. This boot creates a tight seal around the clutch fork opening in the bellhousing…
Ensure secure attachment of your throttle rod or clutch linkage with this factory-correct retainer clip, designed for GM cars and trucks. This clip provides a precise fit and stable connection, preserving the original functionality of your…
Retaining clip for clutch pedal on manual transmision cars and 5/8" pin on automatic transmision cars. One required per car. Clip is included on cluch and brake pedal assembly (W-597, W-598 & W-839). Group 0.837 & 4.634 GM Part #…
Ensure smooth and reliable operation of your vehicle’s brake or clutch pedal with our Brake or Clutch Pedal Bushing Set. Designed to reduce wear and friction, this high-quality set provides a precise fit, improving pedal performance and…
Ensure reliable performance of your clutch system with this clutch pressure plate bolt and washer set, designed for 1955-1981 models. This factory-correct set provides secure attachment of the pressure plate, supporting smooth and…
Correct cover plate which is located on the back of the engine block and is used to cover the flywheel.
Applications:
1962-67 V8 283ci
1962-69 6 cyl. exc. P.G.
1962-69 V8 327ci exc. P.G.
1967-69 V8302ci
1968-69 V8 307ci exc…
Reproduction of the commonly worn out nylon pedal bushings for various GM and Ford vehicles. Split nylon flange bushings fit over clutch pedal cross shaft and inside cross shaft sleeve for clutch and brake pedals with 5/8" diameter cross…
Enhance your clutch performance with the Clutch Cross Shaft Bellcrank Felt Seal Set. Specifically designed to fit various models, these felt seals provide effective protection against dirt and moisture, ensuring smooth operation of the…
Best Quality Reproduction Brake Or Clutch Pedal Pin Clip
Correct Spring Steel
Fits All 5/8" Diameter Pins
For Automatic Transmission Brake Pedals & Manual Transmission Clutch/Brake Pedals
The brake and clutch pedal…
Best Quality Reproduction Bellcrank Stud Heat Treated & Black Oil Finish As Original For Long Service Life Includes Integral Rubber Seal 2.42 Overall Length 1.8 Length Above Mounting Surface 0. Other block side bellcrank studs for the…
This clutch pedal return bumper is designed for cars like the 1964-1967 Buick Electra, Chevrolet Impala, Oldsmobile Cutlass, and many more, with precise measurements of 1-13/16" long, 13/16" wide, and 7/8" high (center). Crafted for…
Reproduction Of Original Fits In Side Of Transmission To Drive Speedometer Cable Green With 22 Teeth Used In 1955-57 Cars With 3-Speed Manual Transmission & 3.55:1 Or 3.70:1 Rear End Ratio Not For Use In Cars Equipped With Overdrive
…
Reproduction Of Original Fits In Side Of Transmission To Drive Speedometer Cable White With 25 Teeth Used In 1955-57 Cars With 3-Speed Manual Overdrive Transmission & 4.11:1 Rear End Ratio
…
Reproduction Of Original Fits In Side Of Transmission To Drive The Speedometer Cable Red With 21 Teeth Used In 1958-60 Passenger Cars With 3-Speed Manual Transmission
…
Secure your flywheel with confidence using this Manual Transmission Flywheel to Crank Bolt Set for 1955‑1972 Full Size Chevy models. Designed to provide a secure, precise connection between the flywheel and the crankshaft, this complete…