DMT Stamped steel door panel clip used on some 60's and 70's Mopars (as well as many Fords and GM cars).
These were used on 68-70 Chargers. 13clips per door panel are required. 3 clips per rear qtr interior panel are required. 32 total
Material(s)
Zinc plated steel clip
Fits 5/16" hole, 3/4" stem length
In 1977, at 15, my first car was a 70 Barracuda I bought for $600 from my dad's co-worker at Chrysler Huber Ave Foundry. Tawny gold, 318, hub caps. Before I could "legally" drive it it had headers and a 4bbl. Had a couple other Mopars after this as a young man.
25 years later it was time to get another Mopar. After looking for 2 years I found a 1971 B5 blue Challenger right here in Michigan. 318 and hubcaps again. This time it cost over 10x as much, $6500. Didn't take long to add wheels, new leaf springs, 340 6bbl, etc. A year or two later I decided to completely redo the car. Had it media blasted and painted B5 blue again BUT when I went to put it back together I found there were no good body gaskets sets for Mopars. The gasket making journey began.
In 2004 I first made a kit to redo my Non A/C heater box using a laser engraver/cutter that I had for another side business. I showed the guys on Moparts and quickly had a few orders. I obviously made all the gaskets for my car because I had all the parts for templates. Many parts fit the other E body models so I soon had all the E body gaskets, then more body style, then more heater box kits and the rest is history.
| Make | Model | Years |
| Dodge | Charger | 1968 - 1970 |
