Reproduction floor pan assembly that is stamped using OE specifications for an authentic replacement of any 1961-64 Impala or Full Size Chevrolet model. This reproduction is just what you'll need if your original complete floor pan is rusted or damaged. Each floor pan features EDP coating for rust prevention. The assembly is designed to allow the restorer the freedom to replace the floor pan section from front to rear without piecing it together by using partial sections. Minor modifications for convertible models required.
Features and Benefits:
Manufactured from new tooling to factory specifications
One-piece design eliminates center seam found on inferior reproductions
Features spot welding under rear seat pans for added strength
Technical Information:
Stamped to OE specifications for authentic fit and appearance
EDP coated for rust and corrosion protection
Covers full floor from firewall to rear seat section
Minor modifications required for convertible applications
Additional Information
Technical Specifications
Measurements: 85" length x 65-3/4" width
Front Seat Floor Braces (RH and LH)
Rear Seat Floor Braces (RH and LH)
Full Rear Seat Brace
Inner Rocker Panels
EDP Coated for Rust Prevention
Holes and Mounting Nuts for Seat and Seat Belt Attachment
Chevrolet Applications
1961 - 1964 Chevrolet Bel Air
1961 - 1964 Chevrolet Biscayne
1961 - 1964 Chevrolet Impala
Note: Shipped truck freight.
Note: Shipped truck freight.
Important:Welding is required. Professional installation is recommended.
Vehicle Fitment:
The Vehicle Fitment Guide is to be used as a general reference. The data has been provided by our suppliers and manufacturers and may contain errors or incorrect data. Always refer to a professional to verify correct fitment for your vehicle.
